solvent comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-06-17. Where a claim depends on a specific study, the study is described rather than over-claimed.
Once a peptide is dissolved, its solution is generally less stable than the dry powder. Chemical pathways such as hydrolysis, oxidation, and deamidation can alter the molecule, while physical processes can form aggregates or cause adsorption to container walls. The rate depends on pH, buffer composition, temperature, concentration, and the specific sequence. Aqueous stocks are therefore kept cold and used within a defined period. Stability testing is usually performed for each peptide rather than assumed from a general rule.
Cold storage slows most degradation but does not stop it. Reconstituted solutions are commonly divided into aliquots and held at -20 °C or -80 °C, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation or precipitation, so single-use aliquots are preferred. Some peptides tolerate refrigeration for short intervals, while others require freezing immediately. Light-sensitive residues may need amber or foil-wrapped containers. The optimal condition remains peptide-specific and should be supported by stability data.
Analytical checks can detect changes in a reconstituted stock over time. Reverse-phase high-performance liquid chromatography can show loss of main peak, new impurity peaks, or altered retention. Mass spectrometry confirms molecular identity and can reveal modifications. Visual inspection for particles, color change, or turbidity provides a simple first check. If a solution shows signs of degradation or contamination, it is typically discarded rather than re-purified in a routine laboratory.
Aseptic technique is used when a reconstituted solution must remain free of microbial contamination. Work surfaces, gloves, and instruments are cleaned, and the septum of a vial is disinfected before solvent is added. A venting needle or pressure equalization can prevent aerosol formation and pressure buildup. Bacteriostatic water contains an antimicrobial preservative, but preservatives can interfere with some assays or alter peptide behavior. Sterile filtration may be used when a formulation cannot be heat sterilized or when particulates must be removed.
Quality control for reconstituted peptides includes recording lot number, solvent, date, and storage conditions. Visual inspection checks clarity, color, and particles, while pH measurement verifies the expected solution environment. Concentration is often estimated by ultraviolet absorbance at 280 nm for peptides containing tryptophan or tyrosine, or by high-performance liquid chromatography. Mass spectrometry can confirm molecular identity before reconstitution. Sterility testing is relevant when microbial contamination would invalidate an experiment, though such testing is not routinely performed in every laboratory.
| Property | Value | Notes |
|---|---|---|
| Storage temperature (reconstituted) | -20 °C to -80 °C | Exact condition depends on peptide, solvent, and stability data |
| Freeze-thaw stability | Limited number of cycles | Repeated cycles can increase aggregation and precipitation |
| Common degradation pathways | Hydrolysis, oxidation, deamidation | Relative rates depend on sequence, pH, and buffer |
| Container material | Low-binding polypropylene | Reduces adsorption loss for some peptides |
| Analytical method for stability | Reverse-phase HPLC | Monitors main peak loss and formation of impurity peaks |
Storage recommendations for reconstituted peptides vary by sequence and intended use, so general rules remain broad. A common laboratory practice is to keep solutions cold, sometimes frozen, and protected from light, but freezing itself can damage certain peptides. The pH of the solution may be adjusted to a range where the peptide is most stable, though changing pH can also alter solubility. Documentation of reconstitution date, solvent, concentration, and storage conditions supports reproducibility. Stability data for a specific peptide are generally established by direct measurement rather than assumed from related compounds.
Once a peptide is in solution, its stability depends on temperature, pH, ionic strength, and the presence of oxygen or light. Many peptides are less stable in liquid form than as dry powders because hydrolysis, oxidation, and aggregation can proceed faster in water. Storage at low temperature slows these reactions but does not eliminate them. Some sequences are particularly sensitive to repeated freezing and thawing, which can cause precipitation or conformational changes. The container material and headspace also influence adsorption and surface-induced aggregation.
Practical handling often includes dividing a reconstituted solution into single-use aliquots to limit freeze-thaw cycling. Vials made of low-binding plastic or glass with inert closures are common, and some protocols add a carrier protein or bulking agent to reduce adsorption. Filtration through a sterile filter may be used when a sterile solution is required, but filters can retain peptide if binding occurs. Mixing is usually gentle; vigorous vortexing can introduce air-liquid interfaces that promote aggregation. Each of these steps involves trade-offs between sterility, recovery, and analytical accuracy.
The concentration of a reconstituted peptide is calculated from the mass of peptide powder and the volume of solvent added. This calculation assumes the powder contains only peptide, but many preparations include counterions, water, or salts. Analytical methods such as ultraviolet absorbance or amino acid analysis can estimate actual peptide content. The relationship between nominal and actual concentration is an area where measurements matter. Open questions remain about how aggregation changes the effective concentration in solution.
Peptide reconstitution is the process of dissolving a lyophilized peptide in a liquid to form a solution for later use. Lyophilization removes water under vacuum, leaving a dry powder or porous cake. Reconstitution reintroduces solvent so the peptide molecules return to a dissolved state. The solvent may be purified water, a buffer, or a mixture containing an organic co-solvent. The choice depends on the peptide sequence, its charge, and its hydrophobicity.
Quality verification after reconstitution may include visual inspection, pH measurement, and chromatographic analysis. Reverse-phase high-performance liquid chromatography can reveal degradation peaks, while mass spectrometry can confirm molecular identity. Concentration may be estimated from the weighed peptide mass or determined by amino acid analysis, UV absorbance, or quantitative chromatography. Documentation of solvent, volume, date, and storage conditions supports traceability and reproducibility. Records also help identify when a solution was prepared and whether it has exceeded an established in-house shelf life.
After a dried peptide is dissolved, the resulting solution is treated as a distinct material with its own stability profile. Temperature, pH, ionic strength, and peptide concentration all influence how long the solution remains suitable for its intended laboratory use. Some sequences are prone to oxidation, deamidation, or aggregation. Because these processes vary widely, no single storage condition applies to every peptide. Buffer composition and light exposure can also shift degradation rates.
Aseptic technique matters when the solution will contact cells or biological reagents. Working in a clean environment, using sterile liquids and containers, and minimizing open-vial time reduce the chance of microbial contamination. Filtration through a sterile filter can remove particles and microorganisms, but some filters adsorb peptides and some peptides are retained by certain membrane materials. Compatibility between the peptide, solvent, and filter should be checked when recovery is critical.
== Career == Bengt Mannervik was Senior Lecturer in the Department of Biochemistry at Stockholm University from 1970 to 1987, and was Acting Chairman for numerous periods between 1971 and 1988. In 1988 he moved to Uppsala University as holder of the Karin and Herbert Jacobsson endowed chair in biochemistry. He was Chairman of the Biochemistry Department from 1998 to 2000. From 2010 to 2012 he was a Senior Professor at Uppsala University, and was a member of the university senate from 2005 to 2008. In 2010 he became Professor at Stockholm University. In addition he is an adjunct professor at the Scripps Research Institute in La Jolla, California, from 2013 to 2029.
== Other uses == Some chemotherapy drugs are used in diseases other than cancer, such as in autoimmune disorders, and noncancerous plasma cell dyscrasia. In some cases they are often used at lower doses, which means that the side effects are minimized, while in other cases doses similar to ones used to treat cancer are used. Methotrexate is used in the treatment of rheumatoid arthritis (RA), psoriasis, ankylosing spondylitis and multiple sclerosis. The anti-inflammatory response seen in RA is thought to be due to increases in adenosine, which causes immunosuppression; effects on immuno-regulatory cyclooxygenase-2 enzyme pathways; reduction in pro-inflammatory cytokines; and anti-proliferative properties. Although methotrexate is used to treat both multiple sclerosis and ankylosing spondylitis, its efficacy in these diseases is still uncertain. Cyclophosphamide is sometimes used to treat lupus nephritis, a common symptom of systemic lupus erythematosus. Dexamethasone along with either bortezomib or melphalan is commonly used as a treatment for AL amyloidosis. Recently, bortezomid in combination with cyclophosphamide and dexamethasone has also shown promise as a treatment for AL amyloidosis. Other drugs used to treat myeloma such as lenalidomide have shown promise in treating AL amyloidosis. Chemotherapy drugs are also used in conditioning regimens prior to bone marrow transplant (hematopoietic stem cell transplant). Conditioning regimens are used to suppress the recipient's immune system in order to allow a transplant to engraft.
A sequence-controlled polymer is a macromolecule, in which the sequence of monomers is controlled to some degree. This control can be absolute but not necessarily. In other words, a sequence-controlled polymer can be uniform (its dispersity Ð is equal to 1) or non-uniform (Ð>1). For example, an alternating copolymer synthesized by radical polymerization is a sequence-controlled polymer, even if it is also a non-uniform polymer, in which chains have different chain-lengths and slightly different compositions. A biopolymer (for example a protein) with a perfectly defined primary structure is also a sequence-controlled polymer. However, in the case of uniform macromolecules, the term sequence-defined polymer can also be used. With comparison to traditional polymers, the composition of sequence-controlled polymers can be precisely defined via chemical synthetic methods, such as multicomponent reactions, click reactions etc. Such tunable polymerizing manner endows sequence-controlled polymers with particular properties and thereby, sequence-controlled polymers-based applications (e.g. information storage, biomaterials, nanomaterials etc.) are developed. In nature, DNA, RNA, proteins and other macromolecules can also be recognized as sequence-controlled polymers for their well-ordered structural skeletons. DNA, based on A-T, C-G base pairs, are formed in well-aligned sequences. Through precise sequences of DNA, 20 amino acids are able to generate sequential peptide chains with three-dimensional structures by virtue of transcription and translation process.
=== Bleeding === Some studies suggest there are risks of upper gastrointestinal bleeding, especially venlafaxine, due to impairment of platelet aggregation and depletion of platelet serotonin levels. Similarly to SSRIs, SNRIs may interact with anticoagulants, like warfarin. There is more evidence of SSRIs having higher risk of bleeding than SNRIs. Studies have suggested caution when using SNRIs or SSRIs with high doses of nonsteroidal anti-inflammatory drugs (NSAIDs), such as ibuprofen or naproxen due to an increased risk of upper GI bleeding.
Sources: en.wikipedia.org
=== As an indicator of volcanic activity === Sulfur dioxide content in naturally-released geothermal gasses is measured by the Icelandic Meteorological Office as an indicator of possible volcanic activity.
=== Surgery === While the total mesorectal excision (TME) operation has become the surgical gold standard for the management of rectal cancer, this is not so for colon cancer. Recently, the surgical principles underpinning TME in rectal cancer have been extrapolated to colonic surgery. Total or complete mesocolic excision (CME), use planar surgery and extensive mesenterectomy (high tie) to minimise breach of the mesentery and maximise lymph nodes yield. Application of this T/CME reduces local five-year recurrence rates in colon cancer from 6.5% to 3.6%, while cancer-related five-year survival rates in patients resected for cure increased from 82.1% to 89.1%.
This material comprises coordinatively saturated Zn4O nodes and fully complexed BDC struts (see above for abbreviation); yet it apparently catalyzes the Friedel–Crafts tert-butylation of both toluene and biphenyl. Furthermore, para alkylation is strongly favored over ortho alkylation, a behavior thought to reflect the encapsulation of reactants by the MOF.
== Calculation == As noted before, DIAAS considers the digestibility of individual essential amino acids (EAAs). The amounts of each amino acid in the test food and in the digested mixture at the end of the small intestine is subtracted to give the absorbed amount of each EAA ai. The value is divided by the total amount of protein in the test food to give the milligrams of each EAA absorbed for each gram of the protein Ai. One then looks up the desired reference pattern, which gives the amount of an EAA in 1 gram of the "reference protein" Ri. For each EAA, the "reference ratio" Ai/Ri is calculated. The final DIAAS is 100% times the lowest reference ratio. Amino acid digestibility is preferably scored using humans. If humans are not available, determination in growing pigs or growing rats are acceptable. For measurement in humans, a minimally invasive dual-tracer method has been developed for the DIAAS method.
What I've said is, let's make long-term spending cuts; let's initiate long-term reforms; let's reduce our health care spending; let's make sure that we've got a pathway, a glide-path to fiscal responsibility, but at the same time, let's not under-invest in the things that we need to do right now to grow. And that recipe of short-term investments in growth and jobs with a long-term path of fiscal responsibility is the right approach to take for, I think, not only the United States but also for Europe.
Sources: en.wikipedia.org
No single time applies to all peptides. Storage life depends on sequence, solvent, concentration, and temperature. Stability should be determined experimentally or taken from supplier data for the specific lot.
Refreezing is possible but repeated cycles are discouraged. Each freeze-thaw step may increase aggregation or loss. Aliquoting before freezing reduces the number of cycles.
Cloudiness, visible particles, color changes, or new peaks in chromatography can indicate degradation. A loss of expected activity in an assay may also suggest a problem. Confirmatory methods include LC-MS and purity analysis.
Storage time varies with peptide sequence, concentration, solvent, and temperature. No single duration applies to all peptides, and a clear solution can still degrade without a visible change.